Mysteriously illuminating from above, below, or within, StarStrip discreetly goes where no light has gone before. Unthinkably thin strips of LEDs adhere to surfaces unfit for traditional fixtures, bathing the most unusual places for a virtually undetectable, surprisingly unpredictable effect.With over twice the lumen output of the basic tape, and the added benefit of it being covered in a pliable clear plastic, StarStrand Super Star, with StarChip technology, excels in performance and durability. The plastic cover keeps dust and dirt from landing directly on the board and makes keeping it clean easy. Super Star is available in pre-manufactured lengths with 4 pin connectors installed at each end for fast and sure installation. The minimum single run is 1, and the maximum run is 50 (Using the 4-Way Connector Accessory). The black PC board is backed with 3M adhesive tape for easy installation.
Over 2 X the lumen output compared to the Basic (171 Lumens/Ft)
Covered in a clear, pliable plastic
Eliminates dust and debris landing on the PC board and diodes
Much easier to clean and dust without coming into direct contact into the PC board and diodes
The cover helps prevent static electricity from damaging the PC board
Minimum run is 1 ft.
Maximum run is 25 ft. before voltage drop
However, if the driver is plugged into the four way connector, you may add another 25 ft. on the opposite side of the original leg doubling the maximum run to 50 ft.
Black PC board backed with 3M adhesive for easy installation
Cuttable every 2 in., but once it is cut, the run is terminated, and it should be capped off with a silicone end cap (53269)
UL listed for damp locations with a IP64 rating
Tested to meet UL standards and carries ETL certifications for the US and Canada
12V Direct Current